• Home
  • About Journal
    Journal Introduction
    Editorial Board
    Youth Editorial Board
    Cooperating Institutions
    Editorial Department
  • Submission Guidelines
  • Policies & Statements
    Ethical Guidelines for Publication
    Academic Misconduct Statement
    Open Access (OA) Statement
    AIGC Use Statement
  • Journal Subscription
  • Download Center
  • 中文版
Cite this article:
LU Jiatong,JIN Jian.Study of reentrainment of cascade impactor used for determination of aerodynamic particle size distribution of dry powder for inhalation[J].Journal Of Pharmaceutical Research,2017,36(3):153-156[Click to copy]
【Print this page】      【Download PDF Full Text】   【View/Add Comment】  【Download reader】  【 Close 】
←Previous|Next→ Archive    Advanced Search
This article has been viewed: 4109times   Download 3701次 QR Code for this article
Scan with your phone!
撞击器法测定吸入粉雾剂空气动力学粒径分布颗粒反弹的研究
卢嘉彤,金坚
Font:Larger+|Default|Smaller-
(江南大学,江苏 无锡 214100)
摘要:
目的 对撞击器(cascade impactor,CI)法检测吸入粉雾剂空气动力学粒径分布(aerodynamic particle size distributions,APSDs)时颗粒反弹和二次夹带进行研究,为涂层材料的选择提供方法。方法 用甘油、硅油分别对收集杯/盘进行涂层或不涂层处理后,分别在30~90 L·min-1流速下,按照《美国药典》601项下规定进行样品收集并分析检测结果。结果 对收集杯/盘进行涂层处理能明显减少滤膜沉积率;用硅油涂层后,相同流速下质量平均空气动力学粒径(mass median aerodynamic diameter,MMAD)不随收集剂量的变化而变化,APSDs也较稳定。结论 使用撞击器法检测吸入粉雾剂APSDs时,对收集表面进行涂层很大程度上能够消除颗粒反弹和二次夹带;新一代碰撞取样装置(next generation impactor,NGI)检测格隆溴铵吸入粉雾剂APSDs时,用硅油对收集杯进行涂层,可使检测结果更准确。
关键词:  涂层  撞击器  颗粒反弹  吸入粉雾剂  体外沉积率
DOI:10.13506/j.cnki.jpr.2017.03.008
基金项目:
Study of reentrainment of cascade impactor used for determination of aerodynamic particle size distribution of dry powder for inhalation
LU Jiatong,JIN Jian
(Jiangnan University,Wuxi 214100,China)
Abstract:
Objective To study particle bounce and reentrainment of cascade impactor used for determination of aerodynamic particle size distributions (APSDs) of dry powder for inhalation.And give an investigation about different coating material.Methods Following the guidance of USP,the samples were made by using cascade impactor,where collection cups/plates were either left uncoated or coated with Glycerin or Silicone oil,at flow rates ranging from 30~90L·min-1.Different does were delivered.Results Coating collection surfaces had reduced the deposition on filter paper.And silicone oil coating had an unapparent impact on mass median aerodynamic diameter (MMAD),and the APSDs were nearly regardless of does.Conclusion This study showed that collection surface coating can eliminate particle bounce and re-entrainment.For glycopyrronium bromide dry powder for inhalation determined by next generation impactor (NGI),the use of Silicone oil as cup coating,preferably with Glycerin, reduced particle bounce.
Key words:  Coating  Cascade impactor  Particle bounce  Dry powder inhalation  FIne particle fraction
Today's Visits:492    Total Visits:2383211
Website copyright:Editorial Board of Journal of Pharmaceutical Research     鲁ICP备17018036号-3     鲁公网安备 37010202001351号
Sponsored by:Shandong Institute for Food and Drug Control Shandong Pharmaceutical Association Address:No.2749 Xinluo Street,High-Tech Zone,Jinan,P.R.China Postcode:250101
Telephone Number:0531-81216586 Email :yaoxueyanjiu@163.com;yaoxueyanjiu@126.com
Technical Support:Beijing Qinyun Technology Co., Ltd.